Floor heating project

Floor heating project
Heating engineering is the radiant floor heating engineering, English Radiant Floor Heating, is based on the entire surface of heat sink through the heat medium radiant floor layer, uniform heating of the ground, the ground heat storage and heat up their own law of radiation conduction from the bottom, to achieve the purpose of heating project.

The use of extruded panels in geothermal heating has the following advantages:
Insulation and heat insulation:Stop the heat or air conditioning through floor loss, reduce air-conditioning, keep the floor surface temperature and room temperature, improve the overall living comfort.
Two 、 sound insulation and noise reduction:To ease the sound transmission structure, enhance the confidentiality of room, remove furniture dragging sound, footsteps on the influence of neighbors, neighborhood improvement. 
Three、Automatic leveling:The slope or fluctuation of the ground can be easily cut and leveled, and the ground is concave and convex, rough and uneven.
Four, full of elasticity:On the floor there is a slight elasticity, make Juegan soft comfortable; to ease the impact of heavy landing, protect the floor, reduce litter damage.
Five, good environmental protection:Corrosion mothproof environmental protection material, water does not rot is not bad, not afraid of insects rat bite.
Six, strong compressive resistance:Long term withstand voltage limit bearing is not less than 2 tons / square meter, even if the furniture long-term pressure, will not make the floor system depression deformation.
Seven, isolated moisture:Antibacterial moisture isolation floor moisture, protection of the floor, you can rest assured that sleeping on the floor.

Different from engineering extrusion plate,“We dedicated to heating extrusion energy-saving board "products are green environmental protection, high efficiency, high compressive strength, low water absorption etc..

The performance parameters are as follows: